Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If you use a metal fude it is much easier for the fab to "option in/out" resistors. Also for testing the closer to the top layer of metal you use the quicker and cheaper for a new mask and easyier to probe.
Poly is more resistive , ie less space however would be prone to more noise.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.