Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Where in this settings I enabled full interrupt ? (UART)

Status
Not open for further replies.
B

BY

Newbie level 4
Joined
Nov 17, 2005
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,317
UART

Hai..

I am working on free scale controllers...I am using SCI where i am able to transmit but i am not able to recieve any thing...The Settings i did are
SCIBDL=0x0D
SCIBDH=0x00
SCICR2=0x2C

where with these settings i enabled the transmitter ,Receiver and receiver full interrupt.


Thanks in advance
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top