Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In order to compare the phase you should have a reference RF signal with same frequency. Synchronization of TX and RX is of utmost importance. Be aware of that.
thank you for your advice. i will care about . my main subject is determening position of an rf signal. i can not determine using only power and want to use phase also.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.