Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

programming flash memory on Altera for nonVolatile Config

Status
Not open for further replies.
S

samuraign

Full Member level 2
Joined
May 18, 2006
Messages
127
Helped
12
Reputation
24
Reaction score
5
Trophy points
1,298
Activity points
1,881
Hi
I am trying for nonVolatile configuration on Altera board.
How to do it.
I am able to configure FPGA using bit file directly.
But in nonVolatile config I need to write into Flash.
 

programming flash memory on @ltera for nonVolatile Config

what board is that?? what is FPGA what is NVEPROM?
 

Re: programming flash memory on Altera for nonVolatile Confi

Stratix 2 DSP Development Board.
FPGA device:- EP2S60
Flash memory:- 16Mbytes of flash memory configured as an 8bit bus.

I have programmed FPGA directly.
But I don't know how to program FPGA by non-Volatile config.
 

programming flash memory on @ltera for nonVolatile Config

o, I see. When I had Stratix 1S10 board, kit came with file called something restored board, so yoy run that file and it restored factory settings, and code on you board. Try to look fir that file
 

programming flash memory on @ltera for nonVolatile Config

Hi, samuraign and Iouri,
Would you two like to post some details about how to programming flash memory? I am a beginner in this field and I need hand-by-hand help. Or I need some documents for designing it step by step. Thanks in advance for your help.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top