Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Image frequency doubt about cosinusoidal/sinusoidal signals

Status
Not open for further replies.
S

STOIKOV

Full Member level 4
Joined
Nov 18, 2005
Messages
236
Helped
8
Reputation
16
Reaction score
2
Trophy points
1,298
Activity points
3,083
Image frequency doubt

in a mixer system, if the band of interest is located in ωRF=ωLO+ωIF, then its image is located in ωIM=ωLO-ωIF.
Both are frequency translated to the same IF because cos(ωLO+ωIF)=cos(ωLO-ωIF).
This is with cosenoidals input signals, but what about if using senoidal input functions ? sin(ωLO+ωIF)≠sin(ωLO-ωIF)
 

Re: Image frequency doubt

I think the problem here is that you're confusing time and frequency domains.
The upper and lower sidebands are at frequencies of wLO+wIF and wLO-wIF. This is the frequency domain; wLO+wIF is a frequency.

Now if, say, the LO and IF are both simple cosine waves, then the output will be 2 simple cosine waves: cos( (wLO+wIF)t) and cos( (wLO-wIF)t), ignoring any phase components and where t is time. This is the time domain; note the 't' in the argument. These are not the same waveforms in any way.

You are trying to evaluate sin( wLO+wIF), without the time parameter and it has no meaning in either domain. I'm not even sure why you declare that cos(wLO+wIF) = cos(wLO-wIF).

Hope this helps.
 

    S

    STOIKOV

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top