Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

a simple question about HFSS parametric study

Status
Not open for further replies.

winglj

Full Member level 4
Joined
Feb 21, 2005
Messages
195
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,063
When I setup the HFSS parametric study for one parameters, it seems the variable that defined in "field calculator" can not be display according to it. Is it the limitation of HFSS?

for example, when I change the plane wave polarization to a metal strip, and want to get the induce current on the strip calcuated by integral of H field around strip. The single runs is OK. But once I set up the parametric studies to change incident wave E field direction, there is the problem that I cannot get the Current vs. E direction in the "results".

Any information will be welcome, thanks.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top