+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Newbie level 6
    Points: 1,216, Level: 7

    Join Date
    Jul 2006
    Posts
    11
    Helped
    1 / 1
    Points
    1,216
    Level
    7

    Help about simulation of LNA using ADS

    Hi all,
    I am novice of ADS. I made a schematic of LNA in ADS. It gave me such error message as follows:
    Error detected by HPEESOFSIM during netlist parsing.
    Instance 'M4":
    'Mode' is not a valid parameter for an instance of 'TSMC_CM018RF_RF_SUBCKT_nmos_rf'.

    Can anyone help me solve this problem? Thanks a lot.
    The schematic is pasted blow.

    •   AltAdvertisement

        
       

  2. #2
    Advanced Member level 5
    Points: 30,904, Level: 42
    BigBoss's Avatar
    Join Date
    Nov 2001
    Location
    Turkey
    Posts
    4,538
    Helped
    1365 / 1365
    Points
    30,904
    Level
    42

    Help about simulation of LNA using ADS

    Define MODE parameter in a "Variable" box.Mode should be generally "OFF","SATURATED","LINEAR"" etc.To find the correct variable, look at modelbook of your technology.



--[[ ]]--