Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

planar inductor simulation problem?

Status
Not open for further replies.
I

icfarmer

Member level 1
Joined
Jun 19, 2005
Messages
32
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,434
I use momentum (in ADS) and HFSS to simulate planar incuctor,but the two inductor values are different as much as 20% and the Q factor is also different. I don't know which is closer to ture value.could anyone give me some suggestion?thanks!
 

For planar structures, ADS is closer if you have set sufficiently meshing density and edge meshing.
this has been proven in many times by developers and designers.

ADS2005A gives the best simulated value for such planar structures.
 

My ADS version is 2004A, is there big difference between ADS2004A and ADS2005A?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top