Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

3 axis engraver control board

Status
Not open for further replies.
C

creative_35

Full Member level 1
Joined
Apr 10, 2006
Messages
95
Helped
9
Reputation
18
Reaction score
3
Trophy points
1,288
Location
Under Mango Tree
Activity points
2,032
Hi friends,
I need to build a parallel port driven 3 axis engraver control board compatible to KCAM. Any of you can provide a circuit , Please don’t guide me to www.luberth.com. I searched and there is no circuits available. I have sanyo denki stepper 1.6A 6V. Unipolar.


Thanks in advance.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top