Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

IRFP250 mosfet maximum voltage on push-pull config

Status
Not open for further replies.
K

kicha

Newbie level 4
Joined
May 21, 2006
Messages
5
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,323
irfp250 power supply

Hi any one help me irfp250 push pull configuration what is maximum dc volt use how to calculate?(Vdss-200V - Rds_on 0.085- Id 33A)
Regards
kicha
 

irfp250n psu

kicha said:
Hi any one help me irfp250 push pull configuration what is maximum dc volt use how to calculate?(Vdss-200V - Rds_on 0.085- Id 33A)
Regards
kicha
Click to expand...

in a push-pull configuration the voltage across the mosfet in off state is double the power supply. Moreover there are spikes due to the leakage inductance of transformer.
The power supply in your case must be less than Vdss/2 = 100V, how much less depend on your trasnformer, a 30% less could be a reasonable margin of safety.
Don't forget to do a good layout of the circuit and wind the two primary of the transformer in bifilar.

stefano
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top