+ Post New Thread
Results 1 to 2 of 2
  1. #1
    Newbie level 4
    Points: 1,318, Level: 8

    Join Date
    May 2006
    Posts
    5
    Helped
    2 / 2
    Points
    1,318
    Level
    8

    irfp250 power supply

    Hi any one help me irfp250 push pull configuration what is maximum dc volt use how to calculate?(Vdss-200V - Rds_on 0.085- Id 33A)
    Regards
    kicha

    •   AltAdvertisment

        
       

  2. #2
    Member level 2
    Points: 2,059, Level: 10
    stefano.delfiore's Avatar
    Join Date
    Apr 2006
    Location
    Italy
    Posts
    43
    Helped
    7 / 7
    Points
    2,059
    Level
    10

    irfp250n psu

    Quote Originally Posted by kicha
    Hi any one help me irfp250 push pull configuration what is maximum dc volt use how to calculate?(Vdss-200V - Rds_on 0.085- Id 33A)
    Regards
    kicha
    in a push-pull configuration the voltage across the mosfet in off state is double the power supply. Moreover there are spikes due to the leakage inductance of transformer.
    The power supply in your case must be less than Vdss/2 = 100V, how much less depend on your trasnformer, a 30% less could be a reasonable margin of safety.
    Don't forget to do a good layout of the circuit and wind the two primary of the transformer in bifilar.

    stefano



--[[ ]]--