salma ali bakr
Advanced Member level 3
i used PACE on xilinx project navigator to assign the pins of my virtex2
but only the banks of the pins were showing
and not the pin numbers themselves
so i wasn't able to specify which ports take which pins BUT the implementation worked fine and i made design rule check and got no errors
how will i know which IO to connect to my kit peripherals if there was nothing to specify exact pin numbers with...
is it something wrong with the software
:?::?::?:
but only the banks of the pins were showing
and not the pin numbers themselves
so i wasn't able to specify which ports take which pins BUT the implementation worked fine and i made design rule check and got no errors
how will i know which IO to connect to my kit peripherals if there was nothing to specify exact pin numbers with...
is it something wrong with the software
:?::?::?: