Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to analyze the signal integrity of PCB with power chip

Status
Not open for further replies.

EDA_hg81

Advanced Member level 2
Joined
Nov 25, 2005
Messages
507
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,808
hperlinx software

I am using TPS65100 (the switching frequency is fixed at 1.6MHZ) triple power supply chip, the problem is how I can analyze the signal integrity of my PCB including this power supply chip.

Thank you.
 

Re: How to analyze the signal integrity of PCB with power ch

Your best bet would be to use Hperlinx tool.

You can run an SI test/simulation on the critical signals that you are warried about by setting up your high frequency switching signal as an aggressor to the sensitive signal(s).

Hope this helps.

Layout Guy
 

    EDA_hg81

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top