Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

get power from 4-20mA signal line

Status
Not open for further replies.

cdcll

Full Member level 3
Joined
Feb 15, 2002
Messages
163
Helped
8
Reputation
16
Reaction score
1
Trophy points
1,298
Activity points
1,199
I need help for how to get 24V/2mA from 4-20mA signal line, any recommendations and experiences are welcome.
 

You probably wouldnot get a full 24v, but I have seen circuits getting about 8 volts from this line. It also depends how much the loop of 4-20ma is powered up with.
 

hello

AD company have several AN on this,you can see the data sheet of AD*693 for lo0p p0wered m/a lo0p.

NS also have several AN on this subject.

bye
 

4 mA max

The current drawn must be lower than 4 mA unless the data you are sending over the line will never be a value represented by low currents.
 

Found somewhere on the net

Schematic foud somewhere on the net ...
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top