+ Post New Thread
Results 1 to 6 of 6
  1. #1
    Newbie level 1
    Points: 1,218, Level: 7

    Join Date
    Mar 2006
    Posts
    1
    Helped
    0 / 0
    Points
    1,218
    Level
    7

    servo motor controller

    how can i drive dc servo motor by using step/dir signals

    •   AltAdvertisement

        
       

  2. #2
    Member level 1
    Points: 1,752, Level: 9

    Join Date
    Apr 2005
    Posts
    33
    Helped
    12 / 12
    Points
    1,752
    Level
    9

    Re: servo motor controller

    Step/dir signals are usually related with stepper motors and not with DC servo motors. Usually DC servo motors are velocity controlled not position (step) controlled) in open loop. If you want to control positon with a DC servo motor you need a positon sensor feedback. Please try:

    Modern Control Engineering, Katsuhiko Ogata...



    •   AltAdvertisement

        
       

  3. #3
    Junior Member level 2
    Points: 2,045, Level: 10

    Join Date
    Dec 2004
    Posts
    23
    Helped
    1 / 1
    Points
    2,045
    Level
    10

    Re: servo motor controller

    "how can i drive dc servo motor by using step/dir signals" <---- This is not enough information.
    You want to drive what? The Velocity or the Position? All is Ok! Just use PID. It is simple and easy to use. Don't ask me what is PID because you can find it on this forum.

    Your control must close loop, not open loop.



    •   AltAdvertisement

        
       

  4. #4
    Member level 5
    Points: 2,655, Level: 12

    Join Date
    Mar 2006
    Posts
    92
    Helped
    17 / 17
    Points
    2,655
    Level
    12

    Re: servo motor controller

    dear semsem,
    the following sites may help you.

    groups.yahoo.com/group/ turbocnc/messages/16201?viscount=100

    www.inocam.com/inodrive

    http://www.astrometric.com/support/d.../IntroSW1i.pdf

    www.globalspec.com/FeaturedProducts/ Detail/ParkerGroup/AC_DC_SERVO_MOTOR_DRIVE_REPAIR/19631/0



  5. #5
    Newbie level 3
    Points: 1,207, Level: 7

    Join Date
    Apr 2006
    Posts
    3
    Helped
    0 / 0
    Points
    1,207
    Level
    7

    Re: servo motor controller

    you said (by using step/dir signals ), I think U need to MATLAP simulation.



    •   AltAdvertisement

        
       

  6. #6
    Member level 4
    Points: 1,585, Level: 9

    Join Date
    Mar 2006
    Location
    libya
    Posts
    78
    Helped
    1 / 1
    Points
    1,585
    Level
    9

    servo motor controller

    hi
    if you have modoling control system by c.dorf



--[[ ]]--