Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem upgrade Pr*tel DXP to SP2 level

Status
Not open for further replies.
T

The Puma

Full Member level 2
Joined
Apr 4, 2002
Messages
134
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
895
service pack 2dxp

When i tried to upgade DXP to SP2 i get a error
MachInit.exe is not a previous version and could not be upgraded.

Why not ??

Have anybody with success upgraded DXP to sp2

Please send me the original MachInit file please

Please help me

Thx
 

You probably: installed Protel, cracked it and then install SP or using SP for Trial on Retail version (or SP Retail on Trial version).

Solution for first situation: uninstall, install again, install SP2 (and find the crack).

Solution for second: download proper SP2 file.

Mickey

PS. It is possible that exe is just damaged (by virus, disk failure or something else) then first solution will be useful.
 

I have a non cracked version. installed with seri@al

i have downloaded the full sp2 package

i will not work
 

Do you have installed SP1? If yes first uninstall Sp1 and next install Sp2. This worked for me.

Good luck.
 

mhmhmh,

I have fresh installed dxp
 

There are two options available for downloading Service Pack 2 for Protel DXP, depending on whether you are using the full licensed version of Protel DXP or the Trial Version. Please make your selection below.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top