Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to noise simulattion in Cadence?

Status
Not open for further replies.
0

020170

Full Member level 4
Joined
Jan 31, 2005
Messages
231
Helped
3
Reputation
6
Reaction score
1
Trophy points
1,298
Activity points
2,221
Could you explain me how to noise simulation in Cadence step by step?

I don't know what should I measure at output.

what is difference between equivalent output and equivalent input?

If you don't want to explain me, give me some article or tutorial paper plz.

thanks
 

pdf on test setup for simulation of noise in cadence
 

Do you mean the NF simulation?
If so, You can make it by using the SP-simulation.
In the SP-Analysis configuration, select the input port and the output port, and then sweep freq. Choose DO noise, specify the output and input port for noise, after simulation,you can get what you want.
I think you can get a clear explation in the spectreRF user mannual.
Best Regard!
 

you have to say what your circuit is. if you have a lna then you run SP if you have a mixer then you need to run pnoise and pss.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top