Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help NEEDED. +100points. EM near-field probe-sensor

Status
Not open for further replies.

costox

Full Member level 4
Joined
Mar 5, 2002
Messages
196
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,298
Activity points
1,539
I'm sorry for bothering you.

I'd like to simulate the following structure (see figure):

a) A 3mm-diameter loop receiver is placed on a small substrate.
b) The receiver and the substrate are then put in a plastic closed-end cylindrical tube (5mm diameter, 0.5mm thick).
c) the excitation-source is placed outside the cylindrical-tube, near the loop. The 100mW excitation can be: plane-wave or a dipole.
d) Is it practical to add lump component to the structure and still able to simulate it fast using A-Designer?.

I included the picture file and the project-file (Ansoft Designer). Could you please fix this file for me (in HFSS or Designer).

Thank you so much.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top