Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Cadence IC + Calibre Interactive on SUSE 10

Status
Not open for further replies.
G

grtc

Newbie level 6
Joined
Apr 10, 2002
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
36
I've installed Suse 10.0, IC 5.1.41 and MG Calibre 2004 all seems to work fine... however, when i try "Run DRC" from the custom Virtuoso Layout "Calibre" menu, it doesnt start up. Running Calibre from command line seems fine and it isn't a license error. Have tried the same with IC 5.0.33 and this has the same issue. Is it something to do with SUSE 10 ??? Would appreciate any help !!!!

Thanks.
 

please post the log file . I think you will need to set the link of the run drc button from virtuoso
 

Generally, it used to be the lic error.

Try to bring up the gui mode c@libre by typing "calibre -gui -drc(or -lvs)".
It starts to check out your lic after
you click the "New Runset" or "OK" button from a pop out "Load Runset File" window.

If this works on yours, then the lic issue can be wipe off.
And you may have to check the environment setting, though it shall check first... :oops:

Regards,
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top