Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to design lowpass filter in PLL (CD4046)?

Status
Not open for further replies.
E

Elits

Member level 4
Joined
Jul 27, 2005
Messages
79
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Indonesia
Activity points
1,982
Hi all,

How to design Low Pass Filter in PLL so I can recovery message From FM which is use frequency carrier = 100kHz. And the message is the human voice?

Thanks
Elits
 

Hi,

Try also this link (hope it helps):

h**p://www.mindspring.com/~redrocker1/PLL_Report/PLL_Report2.htm

Replace * by t
 

Hi,

Also found a design tool:

h**p://www.standardics.philips.com/support/logic/

Scroll down on page

Replace * by t
 

Design a normal passive filter
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top