Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Proteus problem with PIC on COD file

Status
Not open for further replies.
D

donkey41

Full Member level 1
Joined
Feb 19, 2002
Messages
99
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,288
Location
Pakistan
Activity points
949
hello there,

I have tested 16F508 µC with proteus without any problem.
When I try to simulate 16F88 with COD file, it always gives the following error :

[U1] Loading COD file 'J:\pic_tests\16F88_test\16F88_test.COD'
FATAL: [U1] Program or EEPROM data has invalid address [2000] for this device.

However, it doesn't complain if I use HEX format.

Where is the problem and what is the solution ?

regards.
 

Remove user ID location code in your source file.
For example you can comment this code like below:
;IDLOCS CODE ; ID location data, address is in 16f628a.lkr
; dw 0x0102
; dw 0x0304
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top