Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Design of double balanced mixer

Status
Not open for further replies.
T

tony_taoyh

Full Member level 2
Joined
Oct 20, 2004
Messages
131
Helped
6
Reputation
12
Reaction score
3
Trophy points
1,298
Activity points
1,785
Hi,

Now I am design one double balanced mixer,
using Schottky Barrier Diode Quads.

The final layout (draft) is attached.

Can anyone give me some advice on the following issues:
(1) Ribbon wire, Can I use Ribbon wire to cross another transmission
line vertically, or some angle (< 90) needed?

(2) Because, I have two balun, one for LO, another for RF,
which balun should I put the diode near to? RF one or LO one?


Thanks a lot.

Best Regards,
Tony
 

hi, i want to design the balun for wideband,but i dont how to design the balun
i refrence the book mass writted but i simulate the balun ,the result is not good,
can you tell me u how to design the balun
 

what kind of the balun you want ?
active or passive
maybe you can serch ieee paper
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top