001
Junior Member level 3
Hello,
I ac currently having problems with my parallel port. I wrote a program to access the parallel port first using c++ then in perl. With these program, i was able to read and send data to the parallel port(data register) and also to read from them. what surprised me was that the leds which i connected through resistors to monitor the output, did not change at all.
I use Redhat 9.1 W/S. When i checked my hardware brower, there was no parallel port seen but i was the USB port. I use EPP+ECP mode.
I am really confused i dont know what to do now.
001
I ac currently having problems with my parallel port. I wrote a program to access the parallel port first using c++ then in perl. With these program, i was able to read and send data to the parallel port(data register) and also to read from them. what surprised me was that the leds which i connected through resistors to monitor the output, did not change at all.
I use Redhat 9.1 W/S. When i checked my hardware brower, there was no parallel port seen but i was the USB port. I use EPP+ECP mode.
I am really confused i dont know what to do now.
001