Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

help about erasing AT28C256-PI EEPROM

Status
Not open for further replies.

quris_terris

Junior Member level 3
Joined
May 29, 2005
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,513
at28c256 programmer

how can i erase EEPROM AT28C256-PI . i have a genius programmer but it does not erase it , i can only program it by GENIUS programmer . so how can i erase this EEPROM
 

how to erase an eeprom

If you can only program this eeprom then program all locations (from 0 to 32767, or from 0000h to 7FFFh) with FFh, and this will be equivalent to erasing it ..
As an alternative:
The entire device can be erased at one time by using a 6-byte software code.
Here is the explenation on how to do it:
http://www.atmel.com/dyn/resources/prod_documents/doc0544.pdf
Regards,
IanP
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top