+ Post New Thread
Results 1 to 5 of 5
  1. #1
    Junior Member level 1
    Points: 1,456, Level: 8
    saeedakhan's Avatar
    Join Date
    Mar 2005
    Posts
    15
    Helped
    1 / 1
    Points
    1,456
    Level
    8

    Double Side PCB, Top And Bottom Side's Components Placement

    Dear Forum Members,
    Nowadays I Am Working On Signboard Project, In This Project I Have To place the components on both sides of the board.any tips or suggestions of how to accomplish this on ORCARD LAYOUT.NOTE that the components are to be placed on both side's of the board i,e Top And Bottom Side's

    •   AltAdvertisement

        
       

  2. #2
    Newbie level 4
    Points: 1,980, Level: 10
    AlundrA's Avatar
    Join Date
    Feb 2003
    Location
    Ankara Turkiye
    Posts
    6
    Helped
    0 / 0
    Points
    1,980
    Level
    10

    Re: Double Side PCB, Top And Bottom Side's Components Placem

    Which PCB Design software are you using?



    •   AltAdvertisement

        
       

  3. #3
    Full Member level 5
    Points: 3,103, Level: 13

    Join Date
    Aug 2004
    Posts
    258
    Helped
    16 / 16
    Points
    3,103
    Level
    13

    Double Side PCB, Top And Bottom Side's Components Placement

    I usually try to avoid placing anything but small decoupling caps on the bottom side when doing 2-sided layout since this will provide a nice ground plane on the bottom if there are minimal traces on hte layer.



    •   AltAdvertisement

        
       

  4. #4
    Member level 1
    Points: 1,757, Level: 9

    Join Date
    Apr 2004
    Posts
    34
    Helped
    3 / 3
    Points
    1,757
    Level
    9

    Re: Double Side PCB, Top And Bottom Side's Components Placem

    when i draw a two side pcb board , i placed decoupling con on bottom side if you have big pcb design there are a lot of decoupling con i think you place decoıupling con on bottom side



  5. #5
    Member level 2
    Points: 1,535, Level: 8

    Join Date
    Jun 2005
    Posts
    44
    Helped
    9 / 9
    Points
    1,535
    Level
    8

    Re: Double Side PCB, Top And Bottom Side's Components Placem

    Press T button key on the keyboard when you want to place the component on the bottom side. T is for toggling the components between top and bottom side, in ORCAD LAYOUT.



--[[ ]]--