Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Multi modulus divider Phase Noise simulation

Status
Not open for further replies.

NikosTS

Advanced Member level 4
Joined
Jan 30, 2017
Messages
119
Helped
1
Reputation
2
Reaction score
2
Trophy points
18
Activity points
1,054
Hello everyone,
I want to simulate the phase noise of a multi modulus divider at the feedback path of a fractional frequency synthesizer.
The input frequency of the divider , which is the output of VCO, is 16G. The divider then divides this value with an average ratio of 200, which is controlled by a MASH. So the division ratio is changed between 197 and 204 , depending on the output value of MASH.
My question is how can i simulate that phase noise? Which is the correct analysis?

Best regards,
Nikos
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top