Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

DCDC module recovery from input overvoltage involves a time delay?

Status
Not open for further replies.
T

treez

Guest
Hi,

On page 8 of the BCM4414xD1E5135yzz DCDC module datasheet, it says that the Input overvoltage threshold is 420VDC…..and then the recovery from this happens when vin falls to 405VDC.
Does this mean that the module resumes into full operation as soon as its vin falls to 405v, or is there some additional time delay added aswell…eg the 290ms “Auto restart time”?
The datasheet doesn’t make it clear…

BCM4414xD1E5135yzz datasheet
https://www.vicorpower.com/documents/datasheets/ds_BCM4414xD1E5135yzz.pdf
 

Always a good idea to read the manual completely. Review page 13.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top