Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Configuring procedure for UART periphery

Status
Not open for further replies.
Y

yefj

Advanced Member level 4
Joined
Sep 12, 2019
Messages
1,175
Helped
1
Reputation
2
Reaction score
3
Trophy points
38
Activity points
7,063
Hello, I got a Efm32lg230f256 controller. i am looking for a procedure manual in which could see how to configure LEUART0 as UART.
defining stop bit,start bit baudrate etc .
I know that i should look for a periphery in the data sheet(i think i found one as LEUART0) then i need to find what pins are connected to it (gpio) an teh define start bit stop bit etcc.

but its very unclear is there some written example for this proccess?
Thanks.

https://www.mouser.com/datasheet/2/368/Silicon_Laboratories_10252019_EFM32LG-1663778.pdf

https://www.silabs.com/documents/public/reference-manuals/EFM32LG-RM.pdf#page=474
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top