FreshmanNewbie
Full Member level 6
I am capturing 2 different PWM Signals.
The frequency of first PWM signal is lower when compared to the second one.
Please check the waveforms.
All the waveforms are taken of the same two signals. But upon increasing the time base, the second high frequency PWM Signal vanishes like shown below. Why is this happening? Some settings to be changed in scope?
Oscilloscope : HDO6054A Teledyne Lecroy
The frequency of first PWM signal is lower when compared to the second one.
Please check the waveforms.
All the waveforms are taken of the same two signals. But upon increasing the time base, the second high frequency PWM Signal vanishes like shown below. Why is this happening? Some settings to be changed in scope?
Oscilloscope : HDO6054A Teledyne Lecroy