tro2212
Newbie level 5
I am given a DEF, didnt create it myself.
I was able to view the DEF in ICC2. I selected a specific layer (M1), and selected OPC and Area fill shapes. But I dont see any of the FILL shapes. If II select "Fill cell", it highlights the entire cell, and not the shapes inside of it only.
When I stream out this DEF as GDS using ICC2, I can see a fill cell with fill shapes, so I know the DEF has fill shapes. Also reading the textual def, I see the FILLS section and their locations, I just can't "view" them in ICC2 viewer.
Can someone help?
I was able to view the DEF in ICC2. I selected a specific layer (M1), and selected OPC and Area fill shapes. But I dont see any of the FILL shapes. If II select "Fill cell", it highlights the entire cell, and not the shapes inside of it only.
When I stream out this DEF as GDS using ICC2, I can see a fill cell with fill shapes, so I know the DEF has fill shapes. Also reading the textual def, I see the FILLS section and their locations, I just can't "view" them in ICC2 viewer.
Can someone help?