Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

help needed to repair toy quadcopter

Status
Not open for further replies.

fm101

Member level 5
Joined
Apr 13, 2020
Messages
81
Helped
1
Reputation
2
Reaction score
4
Trophy points
18
Activity points
591
hi,

I have a toy quadcopter(attached is picture) which stopped working after using it for around 15 times.

Both the quadcoptor and the flight controller turns on and both are producing sound in its initial state as it used to be before but the motors just don't rotate.

It feels like the rf signal is not received by the controller on the QC.

what can i do to find the fault and repair?

quadc.jpg

thanks
 
Last edited by a moderator:

any problem in the attachment figure? cannot access it.
 

Unless the damage is obvious and visible you stand virtually zero chance of repairing it. It almost certainly contains custom programmed parts that are only available from the manufacturer (probably not the branded name) and you will not be able to get any technical information about it. If you want to proceed, start by tracing the schematic from the PCB, it will not be easy!

Brian.
 

hi,

thanks all for sharing experiences...the battery on both controllers are good....using the same battery on the qc which came with it....
 

Check the part number and datasheet of those IC. If it has a link, related, or control transmit and received signals then just replace it. Hard to check those IC offline.

General repair tips here --> https://elex518.blogspot.com/
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top