Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Read Data From L&T 1 phase meter EM101+

Status
Not open for further replies.

NeethuVP

Member level 2
Joined
Jul 20, 2018
Messages
45
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
352
Hi ,
I am trying to communicate between L&T single phase energy meter. I am using single phase two wire AC Watthour meter and manufactured by Larsen & Turbo .. Model no EM101+
The protocol used for communication is RS232I need to know the commands to retrieve parameters like voltage,current,power etc. from energy meter that I can send from hyperterminal.
I can't find a datasheet of the meter to identify the RX,TX
Thanking you in advance for your kind help. 20200328_150551.jpg
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top