Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Highlight as flattened using Calibre XOR

Status
Not open for further replies.

M.Estupendo

Newbie level 2
Joined
Jun 11, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Hello. How to highlight all differences in the layout as "flattened" and not as "hierarchical"?
I'm using Calibre XOR + rve.
 

You could try flattening all results to the top cell; probably not a good idea if you are working on a large design, though. May want to take a look at flat count to see how many results you will have.
 

You could try flattening all results to the top cell;

This I do not know how to do. In ordinary DRC, there is an option to flatten, but there is no (or i'm missing something) oprion for XOR.
Kindly specify how. Thank you.
 

The flattening happens in RVE. I seem to recall there being a checkbox for "show results in top cell" or something like that.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top