Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Sample and Hold IP3 Simulation in Cadence Spectre

Status
Not open for further replies.
P

Puppet123

Full Member level 6
Joined
Apr 26, 2017
Messages
356
Helped
22
Reputation
44
Reaction score
21
Trophy points
18
Activity points
3,059
I want to measure the IP3 of a Sample and Hold (clocked) using Cadence Spectre.

What is the best procedure for this ? QPSS or PSS ?

I want to sweep over input voltage.

Thank you.
 

Clock+1Large-Tone-Shooting-PSS/1Small-Tone-PAC.

If you need both lower and upper IM3, you have to use Shooting-QPSS.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top