Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to check recevied power in the HFSS port?

Status
Not open for further replies.

Nondegenerate

Newbie level 5
Joined
Jan 5, 2017
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
70
Hi!

I'm simulating a 4*1 receiver antenna array in HFSS. I want to check the antenna performance in the receiving mode. Now I put a plane wave source in the antenna array's far-field. I can observe received E-field and H-field in the substrate moving into the port. But I don't know how to obtain the received power and phase in the port? Can anyone help me on this? Thanks!
 

This sounds like the wrong workflow. Because of reciprocity, you can test the transmit case, which is much easier.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top