+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Member level 3
    Points: 539, Level: 4

    Join Date
    Feb 2019
    Posts
    60
    Helped
    0 / 0
    Points
    539
    Level
    4

    Help with the simulation in Modelsim using ISE 14.5 and simulation code SystemVerilog

    Greetings ... a couple of days ago I have been spending a project done in Vivado 2017.3 to ISE 14.5, because it is required to adapt it to a Virtex5 device. So far I have managed to adapt it and be able to synthesize it, but now I need to simulate the operation of the system using Modelsim SE 10.5. The problem is that the simulation code that was used in Vivado is made in SystemVerilog and it is not possible to use this in ISE.
    Is there any way to use this simulation code in ISE without the need to translate it? Any help is very welcome, thanks in advance.

    •   AltAdvertisement

        
       

  2. #2
    Advanced Member level 5
    Points: 38,501, Level: 47
    Achievements:
    7 years registered

    Join Date
    Jun 2010
    Posts
    6,962
    Helped
    2051 / 2051
    Points
    38,501
    Level
    47

    Re: Help with the simulation in Modelsim using ISE 14.5 and simulation code SystemVer

    ISE is unlikely to support SystemVerilog at all.
    Modelsim should work just fine with SV. What are the problems?



    •   AltAdvertisement

        
       

  3. #3
    Super Moderator
    Points: 32,411, Level: 43
    ads-ee's Avatar
    Join Date
    Sep 2013
    Location
    USA
    Posts
    7,493
    Helped
    1758 / 1758
    Points
    32,411
    Level
    43

    Re: Help with the simulation in Modelsim using ISE 14.5 and simulation code SystemVer

    ISE has virtually no support for SV, they did add a switch to enable what they did add for SV but as I recall it doesn't work that well.



--[[ ]]--