Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Radar Cross Section RCS EM simulation [dBmm²]

Status
Not open for further replies.

elektr0

Full Member level 5
Joined
May 2, 2006
Messages
276
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
3,371
Hi,
could somebody tell me what exactly the outcome of an RCS-simulation, as shown in the attached pic, is.
I guess it is the RCS value, seen by a radar looking at a certain angle to the object.
In the attached example, RCS values are high for Theta~30deg and low for boresight or Theta>50deg.
The object will be quite invisible (undetectable) for Theta>50deg, BUT IT DOES NOT TELL ME into which direction the incoming wave at Theta>50deg will be reflected. Correct?
Best regards,
-e
 

Attachments

  • rcs.png
    rcs.png
    80.5 KB · Views: 129

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top