Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] st-link debugger stops working

Status
Not open for further replies.
H

hamidkavianathar

Member level 5
Joined
Mar 6, 2016
Messages
89
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
804
Hi there
I am developing a software with nucleo-h743zi board. it has a st-link programmer on board. when I run a led blinker example, I can program and debug my code successfully. but when I add freeRTOS and LwIP , .... to my software, I can program my MCU but I can't debug it. I am using IAR IDE. it shows this message:
Capture.PNG

could you please tell me what I should do?
thanks in advance.

- - - Updated - - -

I found the solution. I updated the firmware of my programmer using ST-LinkUpgrade software. now it works well.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top