Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have solved the circuit and calculate Q point. Very simple and easy. But my answers don't match with multisim DC OP analysis.
According to my calculations
VCE = 2.2V
IC = 5.2mA
With multisim the results are totally different.
VCE = 4.6V
IC = 5.3mA
Either it is
* V_C (measured with respect to GND) instead of V_CE (with respect to emitter voltage)
* or you did not simulate steady state (capacitors not charged to steady state)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.