Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Online multisim simulation DC analysis

Status
Not open for further replies.

syeda amna

Full Member level 4
Joined
Jun 1, 2010
Messages
222
Helped
24
Reputation
48
Reaction score
22
Trophy points
1,308
Location
Pakistan
Activity points
2,551
VDB-schematic.png

I have solved the circuit and calculate Q point. Very simple and easy. But my answers don't match with multisim DC OP analysis.
According to my calculations
VCE = 2.2V
IC = 5.2mA

With multisim the results are totally different.
VCE = 4.6V
IC = 5.3mA

Where is the problem?
 

Hi,

V_CE of 4.6V makes no sense.

Either it is
* V_C (measured with respect to GND) instead of V_CE (with respect to emitter voltage)
* or you did not simulate steady state (capacitors not charged to steady state)

Klaus
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top