Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Spectre command line vth output for each monte carlo run?

Status
Not open for further replies.

analogLow

Member level 4
Joined
Nov 18, 2010
Messages
68
Helped
15
Reputation
30
Reaction score
12
Trophy points
1,288
Location
Earth
Activity points
1,785
Hi,

I have successfully run a monte carlo (transient) and extracted the vth for each run (using the "finalOptime") option.

Anyone know how to set this up same vth extraction in spectre command line? Adding the finalOptime option in the command line run only outputs a single monte carlo run. I should in theory be able to copy all settings from the ADE run and get the correct results, the problem is cleanly copying all those results over. :cool:

Thanks,
analogLow
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top