Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Microwave Office Axiem include capacitors etc.

Status
Not open for further replies.

Muichi

Newbie level 2
Joined
Feb 16, 2020
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
16
I want do simulate a diplexer with the axiem simulator. My problem is, that I also need to use a capacitor and a resistor in the design. This works well in the schematic simulation, but produces strange results with the axiem simulator. The S21 attenuation is much to high. I'm using models from the modelithics library. Another strange thing is, that the software immediately shuts down, when I click on 3D EM view. What am I doing wrong? I use Version 14.

Layout.PNG c Layout.PNG

c schematic.PNG c s21.PNG
 

Because EM Simulators Do Not Recognize Electronic Components.You have to place 2-Ports for Cap. then obtain symbol from the layout.
You can use it later on this view in a separate schematic simulation view.
 
  • Like
Reactions: Muichi

    V

    Points: 2
    Helpful Answer Positive Rating

    Muichi

    Points: 2
    Helpful Answer Positive Rating
Thanks for the answer.
Do you have a more detailed instruction for this?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top