+ Post New Thread
Results 1 to 3 of 3
  1. #1
    Member level 5
    Points: 1,037, Level: 7

    Join Date
    Sep 2016
    Posts
    80
    Helped
    0 / 0
    Points
    1,037
    Level
    7

    Gas flow meter + Gas pressure meter + Vacuum meter?

    I have an 8mm hose that flows the gas. Gas is Air or CO2 or Agron. Gas pressure is 0-10bar.

    1.Pressure
    Can you recommend a pressure sensor? 0-10bar, Voltage or digital output, resolution min 12bit, to PCB with 4/6mm hose or direct to 1/8" or 1/4" fitting, low price , I do not resist the Chinese product.

    2. Flow
    I also need to measure the amount of gas flowing through it. Now we use flow meters with a ball any as this

    Is there any cheap method / sensor that can convert flow to voltage for MCU processing?

    3. Vacuum measurement?
    You can recommend a sensor that could be used to measure vacuum
    about differential input, one to atmosferic pressure, second under vacuum , and min 12 bit resolution, voltage or digital output. low price

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 264,047, Level: 100
    Awards:
    1st Helpful Member

    Join Date
    Jan 2008
    Location
    Bochum, Germany
    Posts
    46,141
    Helped
    14034 / 14034
    Points
    264,047
    Level
    100

    Re: Gas flow meter + Gas pressure meter + Vacuum meter?

    2. There's no simple method to add a readout to float-type flowmeter (rotameter). Most economic flow meters (I doubt you find cheap sensors with suitable precision) have thermal or pressure drop operation principle, also some simple turbine flow meters are on the market. Depends much on the intended flow range, precision, gas type.

    For some applications, a rotameter with light barriers can be used as limit switch, e.g. for min/max flow.

    3. Consider if you want to measure pressure below actual atmospheric pressure (differential measurement) or absolute pressure (uses vacuum reference). Depends on your application, both sensor types are available.



    •   AltAdvertisement

        
       

  3. #3
    Member level 5
    Points: 1,037, Level: 7

    Join Date
    Sep 2016
    Posts
    80
    Helped
    0 / 0
    Points
    1,037
    Level
    7

    Re: Gas flow meter + Gas pressure meter + Vacuum meter?

    2. I was looking for a small turbine for gases, but I found them only for liquids
    I need to measure the argon flow 0-10l / min and air flow 0-100l/min
    accuracy is not critical


    3.
    The price is decisive.
    Technically, I need to measure against a reference vacuum.
    Practically I am interested in pressure between 100Pa - 20kPa
    Now I have a large mechanical vacuum gauge, we estimate pressures below 1kPa based on the sound of the pump



--[[ ]]--