T
treez
Guest
Vicor Power Module to power a BLDC Motor & its inverter.....inrush at startup?
Hi
We wish to use a Vicor BCM module to power a BLDC . The steady state max power will be 1200W. The load is a drone motor. (propeller blades)
The Vicor BCM4414xH0E5035yzz power module will be used…..
BCM4414xH0E5035yzz power module datasheet:
https://www.vicorpower.com/documents/datasheets/ds-BCM4414xH0E5035yzz-VICOR.pdf
However, page 3 of the following Vicor App Note on this power module states that the Maximum rated DC current (35A) must “never“ be exceeded……………
Vicor app note 16
https://www.vicorpower.com/documents/application_notes/vichip_appnote16.pdf
The problem is that BLDC’s need to draw a massive current at startup in order to get them to overcome their inertia and start rotating. This will mean that the Vicor power module will exceed its maximum rated DC current (35A) for a short while. (at least its output current will go up to the overcurrent trip point which is anywhere from 37A to 70A).
So do you agree that due to this, we cannot use the BCM4414xH0E5035yzz power module?
Hi
We wish to use a Vicor BCM module to power a BLDC . The steady state max power will be 1200W. The load is a drone motor. (propeller blades)
The Vicor BCM4414xH0E5035yzz power module will be used…..
BCM4414xH0E5035yzz power module datasheet:
https://www.vicorpower.com/documents/datasheets/ds-BCM4414xH0E5035yzz-VICOR.pdf
However, page 3 of the following Vicor App Note on this power module states that the Maximum rated DC current (35A) must “never“ be exceeded……………
Vicor app note 16
https://www.vicorpower.com/documents/application_notes/vichip_appnote16.pdf
The problem is that BLDC’s need to draw a massive current at startup in order to get them to overcome their inertia and start rotating. This will mean that the Vicor power module will exceed its maximum rated DC current (35A) for a short while. (at least its output current will go up to the overcurrent trip point which is anywhere from 37A to 70A).
So do you agree that due to this, we cannot use the BCM4414xH0E5035yzz power module?
Last edited by a moderator: