+ Post New Thread
Results 1 to 12 of 12
  1. #1
    Newbie level 4
    Points: 101, Level: 1

    Join Date
    Dec 2019
    Location
    Kuiv,Ukraine
    Posts
    5
    Helped
    0 / 0
    Points
    101
    Level
    1

    Who has experience using tube...

    Who has experience using tube preamps? How often did the tube change? What problems did you encounter? Click image for larger version. 

Name:	22F3AD57-9CF5-416E-923B-261351442768.jpg 
Views:	11 
Size:	489.5 KB 
ID:	157611
    Telegraph Audio . We shape the music!

    •   AltAdvertisement

        
       

  2. #2
    Advanced Member level 5
    Points: 54,500, Level: 57
    Achievements:
    7 years registered
    Audioguru's Avatar
    Join Date
    Jan 2008
    Location
    Toronto area of Canada
    Posts
    8,893
    Helped
    2087 / 2087
    Points
    54,500
    Level
    57

    Re: Who has experience using tube...

    I used vacuum tubes when I was young, but switched to transistors 58 years ago.
    Tubes wore out and needed replacing (changing?) over and over.
    Rock bands like the distortion produced by tubes and many bands replace the tubes before each show.
    I like the very low distortion produced by transistors and ICs.



  3. #3
    Super Moderator
    Points: 54,801, Level: 57

    Join Date
    Apr 2011
    Location
    Minneapolis, Minnesota, USA
    Posts
    13,346
    Helped
    2654 / 2654
    Points
    54,801
    Level
    57

    Re: Who has experience using tube...

    Not sure if you're asking about amplifiers or just pre-amps...
    I've had tube audio equipment. Tubes are prone to decline in performance with age and use. If a tube gave me doubts there was a tester at my local auto parts store. I put the tube in the correct socket, waited for it to warm up, then dialed a knob selector. A meter indicated the tube's status, good or weak or gassy. It was beyond my ken to experiment with tubes. A high voltage supply is needed, as well as detailed knowledge of pin connections, etc.



    •   AltAdvertisement

        
       

  4. #4
    Advanced Member level 5
    Points: 54,500, Level: 57
    Achievements:
    7 years registered
    Audioguru's Avatar
    Join Date
    Jan 2008
    Location
    Toronto area of Canada
    Posts
    8,893
    Helped
    2087 / 2087
    Points
    54,500
    Level
    57

    Re: Who has experience using tube...

    Many years ago, most "convenience" stores had tube testers and sold replacement tubes because they were so unreliable. Where can you test and buy tubes today? Will they already be used and worn out?
    There was an audio store in my city that sold amplifiers with tubes glowing on top. The amplifiers were solid state with transistors and the tubes were only to see and to feel their heat.



    •   AltAdvertisement

        
       

  5. #5
    Super Moderator
    Points: 83,808, Level: 70
    Achievements:
    7 years registered
    Awards:
    Most Frequent Poster 3rd Helpful Member

    Join Date
    Apr 2014
    Posts
    17,040
    Helped
    3851 / 3851
    Points
    83,808
    Level
    70

    Re: Who has experience using tube...

    Hi,

    There was an audio store in my city that sold amplifiers with tubes glowing on top.
    A modern way of reusing waste....and the customers (like to) pay for it.
    For sure a clever business idea. (not my style)

    Klaus
    Please don´t contact me via PM, because there is no time to respond to them. No friend requests. Thank you.



  6. #6
    Advanced Member level 5
    Points: 31,595, Level: 43
    BigBoss's Avatar
    Join Date
    Nov 2001
    Location
    Turkey
    Posts
    4,643
    Helped
    1406 / 1406
    Points
    31,595
    Level
    43

    Re: Who has experience using tube...

    Someones like tubes due to their their own distortion and sound and nowadays the people who want to listen original sounds pay thousands bucks for tube amplifiers even tube radios..
    Aging is the most common problems for tubes and also performance degrading is another one.They produce also heat like a electrical heater..



  7. #7
    Advanced Member level 5
    Points: 54,500, Level: 57
    Achievements:
    7 years registered
    Audioguru's Avatar
    Join Date
    Jan 2008
    Location
    Toronto area of Canada
    Posts
    8,893
    Helped
    2087 / 2087
    Points
    54,500
    Level
    57

    Re: Who has experience using tube...

    Years ago I took my 1 year old Heathkit tubes amplifier to a MacIntosh amp clinic where they measured 25% distortion and told me to change the tubes. With new tubes it measured 1% distortion. The replacement tubes were fairly expensive to be changed every 3 months or less.



  8. #8
    Advanced Member level 2
    Points: 3,331, Level: 13

    Join Date
    Jan 2019
    Posts
    612
    Helped
    156 / 156
    Points
    3,331
    Level
    13

    Re: Who has experience using tube...

    every decision has its up side and its downside

    tubes are less susceptible to static discharge, EM Pulse, etc



  9. #9
    Member level 4
    Points: 5,781, Level: 18

    Join Date
    Feb 2002
    Location
    Switzerland
    Posts
    70
    Helped
    20 / 20
    Points
    5,781
    Level
    18

    Re: Who has experience using tube...

    For my 2m power amplifier I still use a tube (3CX1500C7). The output power is in the range of 1.5 kW.
    Disadvantage compared to a SS-PA is the high voltage supply (size and weight). Advantage is the robustness against mismatch of the antenna.
    As a transmitter manufacturer (former Ampegon) we still use tubes for the high power (e.g. short wave transmitter 500kW, 3.9MHz - 26.1MHz). The tube for this is the TH576 (Thomson).
    Here is a picture of the TH576 in the 500kW transmitter.


    Click image for larger version. 

Name:	DSCN4504.jpg 
Views:	4 
Size:	503.9 KB 
ID:	157694


    1 members found this post helpful.

    •   AltAdvertisement

        
       

  10. #10
    Advanced Member level 5
    Points: 15,655, Level: 30
    Achievements:
    7 years registered
    schmitt trigger's Avatar
    Join Date
    Apr 2013
    Posts
    2,603
    Helped
    833 / 833
    Points
    15,655
    Level
    30

    Re: Who has experience using tube...

    Quote Originally Posted by TelegraphAudio View Post
    Click image for larger version. 

Name:	22F3AD57-9CF5-416E-923B-261351442768.jpg 
Views:	11 
Size:	489.5 KB 
ID:	157611
    I like tubes, for purely nostalgia reasons.

    A particular problem for preamp tubes, specially in high gain stages, is that poor quality devices may not have been fully evacuated, and the residual gas molecules produce noise.
    That gas will also deteriorate the cathode faster than usual.
    Unfortunately, most simple emission-type testers don't have the capabilities to test for residual gas.

    One question; what is a crowbar doing on top of an audio preamp?
    My batteries are recharged by "Helpful Post" ratings.
    If you feel that I've helped you, please indicate it as a Helpful Post



  11. #11
    Super Moderator
    Points: 32,514, Level: 44
    ads-ee's Avatar
    Join Date
    Sep 2013
    Location
    USA
    Posts
    7,524
    Helped
    1762 / 1762
    Points
    32,514
    Level
    44

    Re: Who has experience using tube...

    Quote Originally Posted by schmitt trigger View Post
    One question; what is a crowbar doing on top of an audio preamp?
    I find the dichotomy of a modern printer (and cables) in what looks like a picture from the 1930s kind of interesting. Even the crowbar looks like it could be hand forged.



  12. #12
    Newbie level 4
    Points: 101, Level: 1

    Join Date
    Dec 2019
    Location
    Kuiv,Ukraine
    Posts
    5
    Helped
    0 / 0
    Points
    101
    Level
    1

    Re: Who has experience using tube...

    Game of words) This preamplifier from the “Limited Edition”, which uses original vintage transformers made in the legendary LOMO factory. The word "crowba" in Russian sounds "LOM". LOM-LOMO)))
    Telegraph Audio . We shape the music!



--[[ ]]--