Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Microcontroller selection - higher baud rate

Status
Not open for further replies.
You might also try one of the PIC18FxxKxx MCUs - they can have a Fosc up to 64MHz. The formulae are slightly different but fundamentally the same.
To get 64MHZ Fosc, you can use a 16MHz xtal and the x4 PLL. Also for certain other frequencies, check out the complete structure of the oscillator module in whatever data sheet you are looking at.
Susan
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top