Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Fixed trap charge specification in Sentaurus TCAD SDEVICE

Status
Not open for further replies.
S

sahal149

Newbie level 4
Joined
Mar 21, 2018
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
39
In Physics section of sdevice, the default charge concentration is given in C/cm3 e.g: (3.8e-16 C/cm3). But if my device is in nanometer scale, what will be the final charge concentration? Does TCAD automatically converts it to nm3 and it will be 3.8e-16 C/nm3? If I want to use 3.8e-16C/nm3 , what will be my value in physics section in cm3 scale?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top