Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to change trace width and spacing of diff pairs in the design using Hyperlynx SI

Status
Not open for further replies.

Eragon777

Newbie level 1
Joined
Jan 2, 2020
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
11
Hi,

I am simulating my postgraduate PCB design project using Hyperlynx SI tool. I am testing on PCIe traces of my design. I did my design using Altium and I exported to Hyperlynx file to do the simulation. I have a issue in TX differential pair of the design. It did not pass the simulation. So I need to change the trace width and spacing of the TX differential pair traces to overcome this problem.
But I cannot change the trace width and spacing of Differential pairs using Hyperlynx SI tool. Is there any way to do that?
If that is so can you tell me steps to do that?

Thanks
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top