Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
FS and SF corners are often not "realistic" (not even as
realistic as the sandbagged SS corner). You cannot, for
example, get a max-spec Tox on the N and a min-spec
Tox on the P channel devices. Same for poly etch (deltaL)
and active area etch (deltaW) and so on.
So putting yourself on the hook for timing closure and such,
for unrealistic events, would add only pain.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
