Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Drive NOKIA 5800 LCD

Status
Not open for further replies.

FAMELC

Newbie level 2
Joined
Dec 29, 2019
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
17
Hi.

I want to drive NOKIA 5800 LCD with microcontroller but my problem is pinout details of LCD connector. I mean, I have no documents or datasheet of it to undrestand about timing and protocol of LCD pins. I also downloaded the relevant files like "Nokia service manual"(LCD pinout attached), but i cant undrestand CDP0 ck- or CDP0 ck+??

Why positive and negative is used??

Thanks a lot.
 

Attachments

  • 5vK9DSV.png
    5vK9DSV.png
    31.3 KB · Views: 70

'-' and '+' probably just refer to the active states of signals, '+' for active high, '-' for active low or they could refer to differential signals. If you show us what they connect to it might give some clues.

Brian.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top